This is an ultra thin RGB LED strip remote control set. Universal Red/Green/Blue (RGB) LED Controller & Dimmer with RF Remote. There are 19 modes and 20 static colors pre-stored in the controller. You can easily change mode, speed, color and brightness of either RGB LED strip or mono color LED strip with it. Features power cycle mode retention and CPS power plug for easy plug and play installation. Maximum load is 4 Amps per channel - 12 Amps total, driving the peak power it delivers to 144w. Sure a good mate for you to create real LED strip project. 4-pin RGB pigtail connector and battery for RF remote included.
-ON / Standby: to turn ON or switch to standby mode
-MODE+ / MODE-: Dynamic mode adjustment. Switch to dynamic mode from static color mode, or change between dynamic modes.
-SPEED+ / SPEED-: Adjust speed in dynamic mode for 5 levels.
-COLOR+ / COLOR-: Static color adjustment. Swith to static color from dynamic mode,or between static colors, 20 static colors.+
-BRIGHT+ /BRIGHT-: adjust static color brightness. Strip will switch to static color if press it at dynamic mode.
-DEMO: switch to Demo mode. At Demo mode, strip will cycle 9 dynamic modes and 3 times for each mode.
Caution: RF remote is driven by 3V CR2025 button battery. Please try to replace with the same type battery.
About the RF Remote:
The RF wireless remote signal can pass through barrier, it gets a longer control distance(about 15 meters at open area) so it is not necessary to aim at the main unit when operating.
Connect 5meter led strip:
Connect 10meter led strip:
It is easy to install. Electric wires and cables are easily connected to the unit through screw down connectors, which makes 100% secure connections.
1) Connect 3 output connection to RGB LED Lights or Monochromatic LED Lights
2) Power up the unit with DC12V power source to the input interface. Make sure each cable is secured in its corresponding slot, avoiding a short circuit.
3) Turn on the power and enjoy.
Construction decoration commercial buildings, airports or subways.
Indoor decoration: hotels, shopping malls, squares, restaurants, bars, houses.
Outdoor decoration: advertising boards, parks, bridges, roads and overpasses, scenic spots.
Others: Decorating for motor vehicles, samples reveal ark and the places needing RGB lights.
The Operating Voltage of this product is DC12/24V. NEVER plug a DC LED Light directly into a wall outlet as this can cause you harm and will damage your LED Lights.
For optimum performance, do not exceed maximum load.
Shorting output wires my cause damage to dimmer.
Always observe proper polarity when connecting power and load.
For indoor use only – this product is not waterproof or weatherproof.
1x RF Remote Controller
1x User Manual
Don’t forget to buy the following:
- DC12V or DC24V Power Supply: it depends on the quantity or length of the LED Lights you will setup. For best use, it should be about 20% stronger (Watts/Amps) than the total required to run your system. How?
- RGB 4pin Connector